Combined metal forming simulation > Useful and User-friendly Functions

본문 바로가기

Useful and User-friendly Functions

Combined metal forming simulation

페이지 정보

작성일posted on

본문

  The material was assumed elastothermoplastic. The dies are elastic. It should be noted that shrink-fit was considered during simulation. Both thermal and mechanical loads are considered for upper die while calculating die stresses. However, only mechanical load for lower die was considered. Effective stresses are shown in this figure. An optimized mesh system was used for this simulation.


 

 

KSTP Fall 2016.


Room A-1209, 12 Dongbu-ro 169beon-gil, Jinju-si, Gyeongsangnam-do, Republic of Korea, 52818

Copyright © 2005 by MFRC and GNU. All rights reserved.

TEL +82-55-755-7529 FAX +82-55-761-7529 MAIL [email protected]

▲ To the top